🚸CDL School Bus — Question 19 of 20
According to the CDL manual, the final step when picking up students at the bus stop is:
Answer: A
Make a final check to confirm all traffic stops before opening the bus door and signaling students to approach.
The final step in safely loading students is to wait until all traffic has completely stopped. Then, open the bus door and signal the student(s) to load.
All choices
- AMake a final check to confirm all traffic stops before opening the bus door and signaling students to approach.
- BPlace transmission in park or neutral and set parking brake.
- COpen the service door just enough to activate the alternating red light when traffic is in a safe distance from the bus.
CDL School Bus Test Info
Questions on Exam
20
Passing Score
80%
Time Limit
Typically 30 minutes; varies by testing location
The School Bus test content is federally standardized, so this question applies in every state. Age limits, fees, and testing procedures do vary — check your state's CDL requirements.
Ready to pass your CDL School Bus exam?
Get full practice exams, study mode, and simulated tests with detailed explanations.
Risk-free — cancel anytime, no charge until trial ends.
Study this on the go
More CDL School Bus Practice Questions
- Which of the following best describes the danger zone of a school bus?
- The zone that extends as much as 30 feet from the front bumper, 10 feet from the left and right sides of the bus and 10 feet behind the rear bumper of the school bus is called what?
- What mirrors are used to see the danger zone?
- The most dangerous time during the school bus ride is:
- Which of the following is the recommended procedure when unloading students?